Safety cover not draining water

[Judge]

Hey everyone,

Has anyone had the problem with water pooling on top of their safety cover? If so what did you do to fix it?

Thanks

 

[proavia]

Use a cover pump to drain it?

 

[1Sammy]

There you go, it is working and doing what it should. Now your pool water is protected from rotting leaves if you have them and dirty snow for those that have it. Perfect set up. Now just to do as "proavia" suggest.

 

[bmoreswim]

I think the replies above would be for a solid cover. Taking a different look at this, is this a mesh cover? If so, it's not tight enough and should not be touching the water. It appears to not be an issue of it not draining, but that it's touching the water which makes draining impossible.

 

[1Sammy]

Ouch, gud catch "bmoreswim" ... My stupid eyes saw Solid but re reading i see that was just a dream

 

[Homebrewale]

Hard to see the springs. The instructions on my Loop-Loc say the springs should be compressed 60%. Also can't see any springs along the edge of the stone wall so I don't see how the cover can be tightened.

 

[sktn77a]

It looks like a mesh cover but the water bulge in the center looks like a solid cover characteristic(?!)

So, Judge, which is it?