So I did some reading on this forum and came across Skippy's pool cooler and decided I wanted to take this on.
I went as far as ordering the same Polaris fittings that he used (I later found out that this was because his pool had a specific polaris return jet that these fittings were designed to work with).
I'd like to be able to screw and unscrew this pool cooler as needed and simply screw back in the return jet that came with the pool, however I learned yesterday that my 1-1/2" threaded fitting that I bought at the local hardware store, does not screw on to this inlet. The inlet appears to be a tiny bit larger then the generic fitting I bought.
I'm hoping someone might have a suggestion for me on how I can make this happen.
Thank You.
I went as far as ordering the same Polaris fittings that he used (I later found out that this was because his pool had a specific polaris return jet that these fittings were designed to work with).
I'd like to be able to screw and unscrew this pool cooler as needed and simply screw back in the return jet that came with the pool, however I learned yesterday that my 1-1/2" threaded fitting that I bought at the local hardware store, does not screw on to this inlet. The inlet appears to be a tiny bit larger then the generic fitting I bought.
I'm hoping someone might have a suggestion for me on how I can make this happen.
Thank You.