Re: Power Light Suddenly off on SWG
Finally, got the new pool up and running this week, installers went ahead and put the salt in, other chemicals, etc...and I figured I'd start learning from there.
Went to turn on the pump today and noticed the "no flow" light was on the SWG. I think it's been on the entire time this week.
So I did some searching on this page and others and gave the sensor a turn and the no flow went away. A few minutes later the "inspect cell" light came on. So I figured since it's been so long since it had been used I'd take it off, give it a rinse with the hose and check for scale. (there was none). I reset the inspect cell holding down the diagnostic button.
After that, the "no flow" blinked indicating a time delay and then the generate light came on for a few seconds. Now, there's nothing on, and the power light which had been working isn't working either. Attempted to turn off and repeat this process and the same occurred again.
I checked the fuse on the motherboard, and it appears to be in good shape. Any other ideas on what it could be? I'm wondering if somehow the power connection on the actual cell got loose when I went to clean it? Any fixes if that were to be the case? I'm including a picture of the motherboard. Not sure if that can be of any use?
Finally, got the new pool up and running this week, installers went ahead and put the salt in, other chemicals, etc...and I figured I'd start learning from there.
Went to turn on the pump today and noticed the "no flow" light was on the SWG. I think it's been on the entire time this week.
So I did some searching on this page and others and gave the sensor a turn and the no flow went away. A few minutes later the "inspect cell" light came on. So I figured since it's been so long since it had been used I'd take it off, give it a rinse with the hose and check for scale. (there was none). I reset the inspect cell holding down the diagnostic button.
After that, the "no flow" blinked indicating a time delay and then the generate light came on for a few seconds. Now, there's nothing on, and the power light which had been working isn't working either. Attempted to turn off and repeat this process and the same occurred again.
I checked the fuse on the motherboard, and it appears to be in good shape. Any other ideas on what it could be? I'm wondering if somehow the power connection on the actual cell got loose when I went to clean it? Any fixes if that were to be the case? I'm including a picture of the motherboard. Not sure if that can be of any use?