This is a 2013 model (LP gas) with electric ignition, when I first turn it on I hear a mechanical click, then it says spark and then after a few sparks the pilot flame lights with a blue flame (turns what I think is the thermocouple glows orange). The pool says "heating" the display and the burners never fire. I am at a loss as to what causes this; I keep reading different mentions that Raypak burners hardly ever clog and am wondering if a component is bad or the board could cause this?
I assume since there are no errors showing via the display that my flow/random safety sensors are working? Do electronics control if and when the burners fire or is this more like a physical clog?
Any help is greatly appreciated!
*EDIT: I also want to note that the LP regulator outside the pool room was replaced 3 years ago by my gas company right before I moved in and when the heater did work the burner flames would often make a flaring noise every now and then. I assume I would see an error code IF the regulator wasn't providing enough gas pressure?
I assume since there are no errors showing via the display that my flow/random safety sensors are working? Do electronics control if and when the burners fire or is this more like a physical clog?
Any help is greatly appreciated!
*EDIT: I also want to note that the LP regulator outside the pool room was replaced 3 years ago by my gas company right before I moved in and when the heater did work the burner flames would often make a flaring noise every now and then. I assume I would see an error code IF the regulator wasn't providing enough gas pressure?
Last edited: