Hello all,
This is the first year trying to start my natural gas heater on my own. I have the water flowing through the heater properly, everything is clean, all wires are connected etc. Here is my problem, when I turn the power on it says the pool temp is 51 degrees, I raise the desired temp so the pool heater should kick in via electronic ignition but nothing happens. The heater doesn't even try to spark or attempt to do anything, the display says "no demand" and then just says "sensor open" and "off" above that. I looked for error codes and I couldn't find any. Gas is on a flowing to the heater. I heard it could be the Thermistor or the Tempature sensor...Is this the case?
Thanks in advance!
This is the first year trying to start my natural gas heater on my own. I have the water flowing through the heater properly, everything is clean, all wires are connected etc. Here is my problem, when I turn the power on it says the pool temp is 51 degrees, I raise the desired temp so the pool heater should kick in via electronic ignition but nothing happens. The heater doesn't even try to spark or attempt to do anything, the display says "no demand" and then just says "sensor open" and "off" above that. I looked for error codes and I couldn't find any. Gas is on a flowing to the heater. I heard it could be the Thermistor or the Tempature sensor...Is this the case?
Thanks in advance!