Just replaced my motor on Friday after the bearings went out. Pool got dark green almost brown while I waited to get time to install. I started SLAMing on Friday morning and the water is clear to the bottom but not as crystal as usual. CYA is between 60 and 70, it's that fine line where it's difficult to tell. FC is 24.5. Family use begging me to get in---y'all think it's ok? Ph is 7.3. I'm hesitant because there's a tad algae left on the deep end wall and the corners of the steps. I've been brushing and roboting, it's just being a little stubborn. Normally I'd make them wait but it's Sunday and you know... Kids. I know I'm safe up to SLAM level, but it just seems borderline to me I guess
Quick safety question
- Thread starter aquaN00b
- Start date
- Jun 22, 2014
- 47,841
- Pool Size
- 17888
- Surface
- Fiberglass
- Chlorine
- Salt Water Generator
- SWG Type
- CircuPool RJ-45 Plus
