Quick Intelliflo Question

Jump to latest Follow Reply
Triumph65

Triumph65

0
Gold Supporter
May 10, 2018
123
Wimberley Texas
Pool Size
48000
Surface
Plaster
Chlorine
Liquid Chlorine
Just had two Intelliflo’s installed. Installer told me to keep an eye on GPM to gauge when to backwash. I backwashed one unit and when I turned back on the display now show Watts and not GPM. It may be because I tripped the breaker to turn off (habit from old pumps).
Next time I guess I should just turn pump off from control panel.

how do I get the pump to display GPM again and not Watts?

I read the manual but cannot figure it out.

Thanks!!
 
You should monitor filter pressure for when you need to backwash. When your filter pressure rises by 25% over clean pressure, it is time to backwash. Select an RPM to record the clean pressure then weekly or as often as necessary run the pump at that RPM to check the filter pressure.
 
  • Like
Reactions: Triumph65
What specific model number IntelliFlo? Pentair makes a bunch of them.
 
  • Like
Reactions: Triumph65
You must log in or register to reply here.
Thread Status
Hello , This thread has been inactive for over 60 days. New postings here are unlikely to be seen or responded to by other members. For better visibility, consider Starting A New Thread.
Top Bottom
Back
Jump to latest Follow Reply