Pumps won’t start up

[Davwil]

Dav,

While all the speeds may have gone away, the programming/scheduling should still be there. Just look at your schedules and make sure you have a corresponding speed. As an example:

Your schedule says that at 1 pm your waterfall will come on and run until 2 pm. You will most likely have a Speed assigned to the waterfall circuit that causes the pump to run at the speed that makes your waterfall look the way you want.

Thanks,

Jim R.

Yes, thanks to everyone's help, I did get it up and running. My screen doesn't look like yours, but apparently when I changed the pump type from VS to VFS it removed the rpm settings, as you mentioned. Once I went back in and assigned rpm settings, the pumps started working again. For the most part, I think I have everything going correctly....at least for now. Thank you again.

 

[Davwil]

@Davwil
In the link below, you'll find a video that I put together some time ago regarding the programming/setup of IntelliCenter Feature Circuits & Circuit Groups (macros) and how to associate those virtual circuits with Pump Speeds and/or Flows as well as Valve Actuator associations.

As you have discovered, the Pentair IntelliCenter documentation is severely lacking to put it mildly. Hopefully, this instructional video can help you out some to get you on the right track.
r.

IntelliCenter Circuits / Pump and Valve Associations

There seems to be quite a bit of questions lately regarding IntelliCenter Feature Circuits and how to associate those circuits with Pump Speeds and/or Flows and Valve Actuator associations. In addition, questions regarding the creation and uses of Circuit Groups (macros) appears to be another...

www.troublefreepool.com

I'll definitely watch the video. Thank you. The documental on the Pentair IntelliCenter has been confusing and lacking to say the least. Thanks again.