Pump question

[JamesW]

What is the pump speed?

Does air come out when you open the air relief?

Do you have a picture of the system?

Did you replace the impeller?

 

[mknauss]

At what rpm are you running the vs pump?

 

[Hemgs1]

What is the pump speed?

Does air come out when you open the air relief?

Do you have a picture of the system?

Did you replace the impeller?

It’s running at the highest speed.

I don’t have a refief on the pro series, I don’t believe.

I did not replace the impeller.

Picture is attached.

 

[JamesW]

Try a new pressure gauge.

 

[Hemgs1]

Anyone know if the buy thing, between the yellow and the motor is supposed to be on the inside or how I have it?

 

[rcerf]

Inside. The yellow piece is a gasket and the other is a lock nut that goes inside to keep the elbow from coming loose.

 

[Hemgs1]

Try a new pressure gauge.

I replaced the pressure gauge to no avail. I did inspect the salt cell and I corrected the issue with “no flow” by splicing the wires. They had been cut. I did notice when I took my salt cell off it sounded like my filter was sucking air from where I disconnected the salt cell. Is that normal or could that be causing my 0 pressure? Is that a sign of an air leak?

This is a new motor, but it seems to be flowing fine. I’ve tried using soap to identify air leaks with no luck.

The sand is probably 4 years old, could that be it?

May have to call a pool guy to troubleshoot this one.