I recently replaced my single speed WhisperFlo pump with a WhisperFlo VST. I wired it into the comp port and thought I had my EasyTouch set up correctly. The pump comes on and runs as intended normally and operates correctly under freezing temps. But when I switch to spa the pump goes to zero speed and stays there. Any ideas what I have missed in my set up. I don't have screen logic so I am programming it from the EasyTouch panel.
Pump not working when switching from pool to spa mode
- Thread starter RMJackson
- Start date
- Jul 21, 2013
- 65,062
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
I did read that online searching for causes, but when I look at my circuit it doesn't show an option to set a VS speed. I wish there was some instructions online.
- Jul 21, 2013
- 65,062
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
RM,
Try... Menu, Settings, IntelliFlo, Pump #1, speeds... Add a speed for the Spa Circuit
Thanks,
Jim R.
Try... Menu, Settings, IntelliFlo, Pump #1, speeds... Add a speed for the Spa Circuit
Thanks,
Jim R.