I have a pentair remote and it stop communicating to my pump. It keeps saying lost communication. I have turned off the breaker in the pentair and even at the main breaker and still wont connect. Any suggestions. Pump and system is only 2 years old .
Pump not starting
- Thread starter Nordygirl1
- Start date
- Jun 22, 2014
- 52,034
- Pool Size
- 17888
- Surface
- Fiberglass
- Chlorine
- Salt Water Generator
- SWG Type
- CircuPool RJ-45 Plus
Perhaps 
NG1,
I assume you have an EasyTouch or IntelliCenter automation system.. Is that true?
If so, your pump should just run automatically, you should not have to push a button to turn it on.
Do you normally have to manually turn on your pump??
Show me several pics of your equipment pad so I can see the automation system and the pump, so I can tell what kind it is..
Then we can figure out if this is a remote issue or system issue.
Thanks,
Jim R.
I assume you have an EasyTouch or IntelliCenter automation system.. Is that true?
If so, your pump should just run automatically, you should not have to push a button to turn it on.
Do you normally have to manually turn on your pump??
Show me several pics of your equipment pad so I can see the automation system and the pump, so I can tell what kind it is..
Then we can figure out if this is a remote issue or system issue.
Thanks,
Jim R.
