Prologic PS-8 System

[medders464]

Hello, can someone please let me know if they have ever experienced this with their Hayward Prologic PS-8 system please let me know. I noticed this morning that when I looked at the remote inside the house a Check System will flash for two seconds and then go back to the time. I have checked the diagnostic menu and no errors are showing up. The system is less than 2 years old. Any advice would be helpful. It has been cold here for the past few days and that's when it started acting up. Please let me know if anyone has experienced this. Thanks!

Greg Medders
Charleston, South Carolina

 

[mas985]

Is only the time showing and not any other item?

Normally, even when off air temp and other items show on the display.

Are you seeing the same thing at the control box display?

At the control box display check for any other lights that are on including the "Service" light.

 

[1poolman1]

Hello, can someone please let me know if they have ever experienced this with their Hayward Prologic PS-8 system please let me know. I noticed this morning that when I looked at the remote inside the house a Check System will flash for two seconds and then go back to the time. I have checked the diagnostic menu and no errors are showing up. The system is less than 2 years old. Any advice would be helpful. It has been cold here for the past few days and that's when it started acting up. Please let me know if anyone has experienced this. Thanks!

Greg Medders
Charleston, South Carolina

Do you have an SWG in the system?

 

[medders464]

Yes, I have a SWG

 

[medders464]

The check system light will blink twice and the time will reappear. I’m seeing this on the controller box as well.

 

[1poolman1]

The check system light will blink twice and the time will reappear. I’m seeing this on the controller box as well.

There are many reasons for a "Check System" error. The attached guide may help. It is usually a sensor, but there are many items that can trigger that message.