Pool light junction box

[PoolUser08]

Long story short, I performed my own electrical work, and when I installed the junction box for the pool lights, I forgot about the spa height. Final inspection correction was to relocate it higher, which I did.

4 Pentair intellibrites with their own 1" conduit runs, and a 3/4" run to the transformers.

Looking to see if this is up to code or sufficient or if need to support it another way? Thanks

 

[PoolGate]

I believe code for those is just high enough to clear the water levels. But when you raised them, how did you extend the wires? Did you splice it in the conduit?

 

[PoolUser08]

They were located about 2 feet from the concrete, I back trenched and had enough wire to raise the jbox. No splicing.

I removed the unistrut and used a 2x4 to support the box. Inspector showed up today and signed off my final inspection.