Pool light junction box

PoolUser08

New member
Dec 21, 2020
2
California
Long story short, I performed my own electrical work, and when I installed the junction box for the pool lights, I forgot about the spa height. Final inspection correction was to relocate it higher, which I did.

4 Pentair intellibrites with their own 1" conduit runs, and a 3/4" run to the transformers.

Looking to see if this is up to code or sufficient or if need to support it another way? Thanks20201221_112336.jpg

20201221_112353.jpg
 

PoolGate

Gold Supporter
TFP Guide
Jun 7, 2017
5,392
Damascus, MD
Pool Size
29000
Surface
Plaster
Chlorine
Salt Water Generator
SWG Type
Jandy Aquapure 1400
I believe code for those is just high enough to clear the water levels. But when you raised them, how did you extend the wires? Did you splice it in the conduit?
 

PoolUser08

New member
Dec 21, 2020
2
California
They were located about 2 feet from the concrete, I back trenched and had enough wire to raise the jbox. No splicing.

I removed the unistrut and used a 2x4 to support the box. Inspector showed up today and signed off my final inspection.
 
Thread Status
Hello , There was no answer in this thread for more than 60 days.
It can take a long time to get an up-to-date response or contact with relevant users.