Polaris P955 Error Code 10

[MarkHoop]

I have the above error and have done the following:
1 - Checked for corroded contacts (None)
2 - Checked cable continuity from one end to other (No issue)
3 - Removed Motor Block (Type D) and no signs of seal leak
4 - Powered up Motor Block while removed from unit - impeller motor spins for a few seconds and then stops and Error 10 appears on the display

Anything that I should check that I haven't already that may save me a trip to the service depot??

Much appreciated

 

[MarkHoop]

Hi Folks,
New to the forum and have read some of the somewhat related links. Here is what I have done to date with my robot
1 - Checked continuity of cable from connector at motor drive to connector at control box (No issues)
2 - Check for any pin oxidation in control box end (None found)
3 - Removed the motor drive (No signs of any leakage)
4 - Connected Motor Drive to Control box while removed and started program (Impeller motor ran for a few seconds and then stopped with Error Code 10 showing in the display)

Is there anything else that I should be checking before I go the route of taking it to a service depot for further troubleshooting?

Thanks

 

[romeo17]

Hi, I have the same issue. Were up able to resolve this? what steps did you take?

 

[MarkHoop]

Did resolve this with a new cable.