The system is a hayward pro-logic which has chlorine generator, heater and acid dispenser, and the salt in the pool is @ 3800ppm currently, the system is set to keep chlorine at 725 which it does perfectly.
We have a 2 speed Hayward pump that is recommended to be on high speed for a min. of 8 hrs. That being said, I was told by other members that my pump is running too much, so i tried to dial the run time down and the Ph plummets to around 5.7 which isn't acceptable.
The problem is that the Acid dispenser times out after 120min of inactivity. So if i'm not around to check the panel (cause i'm at work all day) there is no way for me to reset the default timeout (start it over) function AND the pump is on low speed, i get home to very low Ph levels. AND the acid is set by hayward to only work on HIGH speed
Does anyone have a similar problem?
I did pick up some soda ash this weekend but still havent added it. I'm just not sure whether running the pump LONGER is the best idea since no one is in it from Mon-Thur
We have a 2 speed Hayward pump that is recommended to be on high speed for a min. of 8 hrs. That being said, I was told by other members that my pump is running too much, so i tried to dial the run time down and the Ph plummets to around 5.7 which isn't acceptable.
The problem is that the Acid dispenser times out after 120min of inactivity. So if i'm not around to check the panel (cause i'm at work all day) there is no way for me to reset the default timeout (start it over) function AND the pump is on low speed, i get home to very low Ph levels. AND the acid is set by hayward to only work on HIGH speed
Does anyone have a similar problem?
I did pick up some soda ash this weekend but still havent added it. I'm just not sure whether running the pump LONGER is the best idea since no one is in it from Mon-Thur