Pentair VSF programming question

[Chuckiechan]

I used the “time out” function to do some maintenance. Then I pressed “program 1”. How do I get it back into the program so it shuts itself off. Its past shut off time, and it is still running.

Thanks in advance.

EDIT: I think I stumbled in to it.

 

[mknauss]

Best to use SERVICE when wanting to control the pump. Then when you go back to Auto, your normal schedule will run.

 

[Chuckiechan]

I’ve only got “quick clean”, “time out”, “start/stop”, “reset” buttons. No service or auto.
I think I got it though. When they replaced my motor, they replaced the electronics too, and I think it did go directly from time-out to on-off (meaning on to run program).
I’ll be experimenting until I get used to it. BTW, I took your advice and run at 1000 RPM.

 

[mknauss]

I assumed you had an Easytouch. Guess not. Sorry.

 

[RJPRESTRIDGE]

I have the Pentair VSF also - after I'm finished with a manual program selection, I hit the Start/Stop twice. First to stop the current program and then to reset to whatever program is scheduled.

 

[Chuckiechan]

Got it. It’s working now. When they replaced my motor, the replaced the drive (AKA the electronics). Either way, all is good.