Just installed the above pump and I’m using the app to set up programs. I have four programs set but for some reason instead of showing the proper next program that will run. It shows the improper program that will run. All my times are set correctly and any help is appreciated. Program 4 should run next, but you can see. That’s not the one that it says. If I delete program 3 that it says we’ll run next it then shows program 4 will run as the next program. But if I re-create program 3, it goes back to the next program to run.
Pentair vsf 1.5 hp program issue
- Thread starter mdhwoods
- Start date
Program 2 and 3 are very similar except for time duration.
I would delete one of them and make the other 9am to 9am (24 hrs)
Most VS pump programs will only run the highest speed when there is an overlap of schedules.
So what I expect to happen is as follows
9am Pump is on at 28%
10am pump speed ramps up to 65% for 1 hr then goes back down to 28%
At 10pm pump speed ramps up to 65% for 1 hr then goes back down to 28%
Let us know if this works.
I am not sure but the 24 hr low speed schedule may need to be Program 1.
I would delete one of them and make the other 9am to 9am (24 hrs)
Most VS pump programs will only run the highest speed when there is an overlap of schedules.
So what I expect to happen is as follows
9am Pump is on at 28%
10am pump speed ramps up to 65% for 1 hr then goes back down to 28%
At 10pm pump speed ramps up to 65% for 1 hr then goes back down to 28%
Let us know if this works.
I am not sure but the 24 hr low speed schedule may need to be Program 1.
So i tried that originally, and it was not running one of the schedules. I’ll try again. New schedule attached. Ill see if it runs both clean programs now.
