I noticed today while my pump was running in routine "filter" mode, that a small amount of water was dripping out my waste pipe by the road (I noticed the ground was a little wet and it hadn't rained in a while). So I inspected the multiport valve (not sure if this is the correct term for it) and noticed that the looking glass was half full with water also. The multiport valve and handle was changed only a few months ago (I think 3 months), so it's relatively new. What could be the issue guys? Praying it's a simple fix! I know water shouldn't being getting through the "backwash/waste/rinse" line when the valve handle is on filter right? I'll post some pics of my setup.