Hi,
A new Intelliflo 3 pump was acquired for a Intellipool automation system.
The pump seems to communicate with the Intellipool system but not entirely.
While the pump indicates with a magenta led that it is being controlled by an automation system, it seems to alternate between yellow "idle" status and flashing green "priming" status. The Intellipool system indicates that an Intelliflo pump has been connected but displays 0rpm although the pump is running at max rpm during priming. This goes on for more than an hour or until interrupted. The intellipool system firmware has been upgraded to the latest available (5.06) firmware. When running the Intelliflo pump in standalone mode and controlled via bluetooth or the pumps built in timer program, the pump is working perfectly and doesnt cycle between idle and priming.
Any suggestions?
Thanks in advance,
//Andy
A new Intelliflo 3 pump was acquired for a Intellipool automation system.
The pump seems to communicate with the Intellipool system but not entirely.
While the pump indicates with a magenta led that it is being controlled by an automation system, it seems to alternate between yellow "idle" status and flashing green "priming" status. The Intellipool system indicates that an Intelliflo pump has been connected but displays 0rpm although the pump is running at max rpm during priming. This goes on for more than an hour or until interrupted. The intellipool system firmware has been upgraded to the latest available (5.06) firmware. When running the Intelliflo pump in standalone mode and controlled via bluetooth or the pumps built in timer program, the pump is working perfectly and doesnt cycle between idle and priming.
Any suggestions?
Thanks in advance,
//Andy