Pentair Easytouch Light Issues (wrong color and sometimes fails to turn on)

[Danimal86]

Well, not sure where to go from here. I suspect some of the bulbs are on the blink, but hard to say. The ET just turns them on and off to set the color. There is no fancy programming or software. Very basic.

Seems like only the red in the deep end
..how bad are these to replace.

Diy'able?

 

[mknauss]

Not bad. Can get expensive.

 

[Danimal86]

Not bad. Can get expensive.

Dang the big one is $1k.
These things repairable?

 

[mknauss]

I don’t believe so. The two Intellibrite could be changed to an off brand, but the Globrite would not sync with it. I believe you are in a box on this one.

 

[Danimal86]

I don’t believe so. The two Intellibrite could be changed to an off brand, but the Globrite would not sync with it. I believe you are in a box on this one.

I'm not sure if this is a match, but looks like theirs hope for possibly replacing just the board. I'll have to dig in and try to figure out the exact model number.

 

[mknauss]

You are right, you can get just the engine. InyoPools has them, but at much higher prices. Ebay always invokes caveat emptor.