Does anyone know the part number for the Pentair CV-24 valve stem (my terminology) in the attached diagram? I ran into the valve handle with my mower and it sheared off the stem at the outer case. Thankfully, it is only used for the waterfall and bubblers so it does not rotate automatically all that often. Is there a problem leaving it this way in the short-term until I repair it?
Pentair CV-24 Valve Stem Replacement
- Thread starter gmichal
- Start date
- May 3, 2014
- 62,698
- Pool Size
- 6000
- Surface
- Fiberglass
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-40
If it still turns, there is really no need to fix it. All the handle does when attached is show you which direction the valve is set.
Might try InyoPools for the part.
Might try InyoPools for the part.
- Jul 3, 2013
- 9,027
- Pool Size
- 15000
- Surface
- Vinyl
- Chlorine
- Salt Water Generator
- SWG Type
- CircuPool SJ-40
It does not look like they sell that part 
www.inyopools.com
Pentair / Compool Actuator CVA-L24 Parts - INYOPools.com
Pentair / Compool Actuator CVA-L24 - INYOpools.com has the largest selection of swimming pool and spa replacement parts with over 70,000 parts in stock. Order today and save!
www.inyopools.com
- May 3, 2014
- 62,698
- Pool Size
- 6000
- Surface
- Fiberglass
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-40
For the prices on those parts, I would get a new actuator. Intermatic makes some that are not a lot more than $100.
- Jul 21, 2013
- 65,256
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
Keep your eyes out on threads where folks are replacing their actuators for other reasons and see if you can get a parts donor.