Hi there, so I have a hayward filtration system (cartridges) I Just recently installed a new motor in. now I have a open water valve sensor system check light is on. i'm not sure if I was suppose to do anything with that sensor to connect to the new motor? or if I installed the motor wrong or something? I looked at the wiring and it looks like it's not damaged. any suggestions on what I should do?
open water sensor
- Thread starter Kiki_Lily
- Start date
- Jul 21, 2013
- 53,182
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
Welcome to TFP.
You have a Hayward Prologic or Omnilogic system?
An open water sensor is referring to the water temperature sensor. You may have knocked loose a wire when installing the pump.
We need to know the details of your pool and equipment. Please create your signature.
You have a Hayward Prologic or Omnilogic system?
An open water sensor is referring to the water temperature sensor. You may have knocked loose a wire when installing the pump.
We need to know the details of your pool and equipment. Please create your signature.
- Jul 21, 2013
- 53,182
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
You have a Prologic system or Aqualogic system?
Your manual is here --> https://hayward-pool-assets.com/ass...-PL-PS-x&PL-PS-x-VInstallationOct08&Later.pdf
See page 19 for location of the temperature sensor connection. Check the wire connection. If the wiring is good then check the sensor using a multimeter.
www.troublefreepool.com
Your manual is here --> https://hayward-pool-assets.com/ass...-PL-PS-x&PL-PS-x-VInstallationOct08&Later.pdf
See page 19 for location of the temperature sensor connection. Check the wire connection. If the wiring is good then check the sensor using a multimeter.
Temperature Sensors - Further Reading
www.troublefreepool.com