OmniLogic Smart transformer to control Low Voltage Lighting

[opnprlinky]

Reading through the multitude of information I believe I should be able to hook up a low voltage lighting to the smart transformer. Inside the Smart transformer there are four low voltage, outputs zones. Zone one is what is running the lights within the pool. I attempted to hook up an LED low voltage light to one of the other zones and then go through The configuration of the Omni PL to configure the LED light. Not an output on the low voltage zones in the transformer. I feel that I am missing something and hoping that someone on this forum can assist thank you.

 

[ajw22]

You need to update your MSP version and probably the Smart Power version.

 

[opnprlinky]

Haven’t had a chance to play with it for awhile but wife and kids are on a trip so thought I would try your suggestion AJW22 and it worked. Now I just need to run the wire and hook up some landscape lights. Thank you very much

 

[opnprlinky]

Haven’t had a chance to play with it for awhile but wife and kids are on a trip so thought I would try your suggestion AJW22 and it worked. Now I just need to run the wire and hook up some landscape lights. Thank you very much

It was working per the recommendations above. I ran about 100’ 14/2 wire and hooked up 4 LED lights then once I turned the lights on they just flash. I’m wondering if I have wrong light type selected although I tried a few different options. Any help greatly appreciated. Also can anyone confirm they have used the smart transformer to power non Hayward LED lights? Thanks again