OmniLogic Pool spa Mode

[mnh]

Hi,
I have a pool and spa that are completely run on separate equipment, except they share the same Hayward heater. Recently we needed to replace two actuator valves. We were able to get them operating through the app correctly so that when you select heat on either pool or spa it heats the appropriate body of water.
My problem is in the app it says it's always in pool mode even when it is heating the spa. Then it seems to randomly switch the valves back to pool mode without any input. Any help would be appreciated thanks

 

[ajw22]

Welcome to TFP.

Someone designed and installed a non-standard setup for what you have. We need to see it to jelp you understand how it operates.

Post pics of your equipment pad and valves whn your pool si ehating and your spa is heating.

And we probably need to see the inside wiring of your Omnilogic system.