Just replaced the PCB main board because of high salt cell volts and amps. Entered all the configuration info like it was on old board. Now the salt cell is working properly but now the heater will come on light off and run for about 1 minute then flame out then shut off. Any ideas of what I might have entered wrong on new card. The heater was working fine before this change out. The heater is a Hayward H400IDL2.
Now the heater.
- Thread starter hodt
- Start date
The display on the heater is not showing anything. Almost like the display is not working.
Yes. It's controlled thru the aqua logic panel. The old card had it set up on heater1 and that's how I configured the new card.
Yes. The control wire is connected to the heater1 location and heater1 is enabled in the config menu.
I have the same question about power. Normally when the heater lights there is power. Shutting down after a minute could be no flame recognition. You should have a code like IF?
Well if the heter lights as you say, then you have power to the unit. I would try and take it out of bypass operation and see if you can manually run the heater.
Here is the manual, https://www.parts4heating.com/v/vspfiles/images/pdfs/HSLowNOxID.pdf, Pages 18/19 talk about the bypass operation of which you use when it is connected to an automation system.
Here is the manual, https://www.parts4heating.com/v/vspfiles/images/pdfs/HSLowNOxID.pdf, Pages 18/19 talk about the bypass operation of which you use when it is connected to an automation system.