I'm new to this website and was hoping to find some answers and suggestions to better educate myself on the Hayward Omnilogic control panel. Presently there is an Alarm displayed on the Omnilogic display screen stating "No Water Flow Timeout FlowSensor".
This went on for 3-4 days after opening and than was cleared for a few days with me doing nothing. Now it’s back to doing the same thing.
I’ve checked the sensor itself and it’s all intact. I’ve replaced the filter to ensure that’s clean and new.
Has anyone ran into this condition and if so what were the resolutions taken to resolve the alarm? Thank you
This went on for 3-4 days after opening and than was cleared for a few days with me doing nothing. Now it’s back to doing the same thing.
I’ve checked the sensor itself and it’s all intact. I’ve replaced the filter to ensure that’s clean and new.
Has anyone ran into this condition and if so what were the resolutions taken to resolve the alarm? Thank you
