Howdy everyone! My new 12,000 gallon fiberglass pool is up and running, we poured the salt in and the pump has been running for about 6 hours now. I tested my water (twice just to be sure) and these are my numbers with the TF-100 kit:
FC - 5
pH- 7.8 (this is quite difficult to read, I used two different test kits and then did the acid demand test to correlate)
TA - 500 (yes it's 500ppm I double checked)
CH - 75
CYA - 0
Salt - 2930
Temp- 90F
CSI - .36
The pool is cloudy and a slight green color but it still has a lot of sand/silt from the construction process. They told me to run the pump 24/7 and clean the filter 1-2x a day for the first week.
What is my priority here? Should I add anything today (6:20pm here) or wait until tomorrow morning and re-test then add stuff? Can I add different things at the same time like say muratic acid and cya?
Thanks!
FC - 5
pH- 7.8 (this is quite difficult to read, I used two different test kits and then did the acid demand test to correlate)
TA - 500 (yes it's 500ppm I double checked)
CH - 75
CYA - 0
Salt - 2930
Temp- 90F
CSI - .36
The pool is cloudy and a slight green color but it still has a lot of sand/silt from the construction process. They told me to run the pump 24/7 and clean the filter 1-2x a day for the first week.
What is my priority here? Should I add anything today (6:20pm here) or wait until tomorrow morning and re-test then add stuff? Can I add different things at the same time like say muratic acid and cya?
Thanks!