We just got our new in-ground spa going. We have a separate booseter pump, so we use that when we want jets on. So, really our filter pump in spa mode is just used for the heater.
The default RPMs was 3350, but that's because it generates bubbles at that RPM from the jets that do the heating.
What RPMs does everyone recommend for just heat and no bubbles? I set it to 2950 and no bubbles, but would prefer to set even lower if I can (E.g., 2650). Is there a minmum RPM required to ensure a good flow rate through the heater? Circ pump is an Pentair VSP IntelliFlo.
Thanks!
Sorry - I realize this should be in the SPA forum. APOLOGIES.
The default RPMs was 3350, but that's because it generates bubbles at that RPM from the jets that do the heating.
What RPMs does everyone recommend for just heat and no bubbles? I set it to 2950 and no bubbles, but would prefer to set even lower if I can (E.g., 2650). Is there a minmum RPM required to ensure a good flow rate through the heater? Circ pump is an Pentair VSP IntelliFlo.
Thanks!
Sorry - I realize this should be in the SPA forum. APOLOGIES.