At this point not happy PB but no turning back now, day 26, have water and equipment but no electrical. Have been waiting for electical for 10 days.
Waterline on one end is about 1/2" lower then the other measuring from the cap, pool is only 24' long, is this acceptable?
Also about 3" of the liner has pulled out in that corner, I would assume due to this difference, will this be an ongoing problem?
Attached picture of joint on oppisite side by steps, should I be seeing a gap and the top of pool liner?
Trying to head off and document anything that may lead to continual problems.
As you can see pool is now a pond, they will be doing initial setup, anything I need to watch out for when the SLAM/Shock the pool. Have been reading that possible equipment damage is not done properly.
Any input would be appreciated.
Waterline on one end is about 1/2" lower then the other measuring from the cap, pool is only 24' long, is this acceptable?
Also about 3" of the liner has pulled out in that corner, I would assume due to this difference, will this be an ongoing problem?
Attached picture of joint on oppisite side by steps, should I be seeing a gap and the top of pool liner?
Trying to head off and document anything that may lead to continual problems.
As you can see pool is now a pond, they will be doing initial setup, anything I need to watch out for when the SLAM/Shock the pool. Have been reading that possible equipment damage is not done properly.
Any input would be appreciated.