New jandy temperature sensor for iAqualink that doesn't have one

[AmberCrest]

Hi all... To my surprise, the pool we acquired with the home we're slowly moving to doesn't have a water temperature sensor. I just replaced the old defective Aqualink board and there are wires connected butbi now see they only get about 8 inches out of the box. Best guess, pipes froze and the sensor was lost in the repair.

Anyway, I've seen sensors from $10 to $200 so I'm looking for a few recommendations.

Thanks in advance!

 

[ajw22]

@1poolman1 recommends these inexpensive sensors and says they are as good as the expensive Jandy sensors. The savings can be worth it even if you have to go through a few to get an accurate one.

Test the new sensor using a multimeter as described in Temperature Sensors - Further Reading

Amazon.com

 

[AmberCrest]

@1poolman1 recommends these inexpensive sensors and says they are as good as the expensive Jandy sensors. The savings can be worth it even if you have to go through a few to get an accurate one.

Test the new sensor using a multimeter as described in Temperature Sensors - Further Reading

Amazon.com

Many thanks...
Ordered along with some stainless steel hose clamps as I do not see a zip tie lasting.