Rvm76
New member
Hello @zamazing
New on this forum but just want to say thank you, your explanation and screenshot of the required jumper change on the main aquarite board solved my issue. This is an omission from Hayward, it should be part of the installation process.
To summarize the work, if anyone is considering undertaking the work themselves:
- I have an aquarite 900, t-925 cell and Omnihub
- Bought the daughter board online and installed it myself (i am not very hands-on but it's fairly manageable, the daughter board instructions booklet is quite straightforward, except for the missing jumper part explained in zamazing's post). You need screwdrivers and a hammer to knock out the cable opening in the aquarite, that's about it.
- Did the configuration wizard and added the chlorinator (To enter config mode, you need the config password which in my case was my MSP Id)
- Started receiving chlorinator communication error messages. Jumped on Google found this thread and resolved it by moving the jumper to the primary position.
- When i powered everything back on the Remotely Controlled light went on during system bootup
- At that point the chlorinator is visible and controllable in your omnilogic system or via mobile app
Thank you
New on this forum but just want to say thank you, your explanation and screenshot of the required jumper change on the main aquarite board solved my issue. This is an omission from Hayward, it should be part of the installation process.
To summarize the work, if anyone is considering undertaking the work themselves:
- I have an aquarite 900, t-925 cell and Omnihub
- Bought the daughter board online and installed it myself (i am not very hands-on but it's fairly manageable, the daughter board instructions booklet is quite straightforward, except for the missing jumper part explained in zamazing's post). You need screwdrivers and a hammer to knock out the cable opening in the aquarite, that's about it.
- Did the configuration wizard and added the chlorinator (To enter config mode, you need the config password which in my case was my MSP Id)
- Started receiving chlorinator communication error messages. Jumped on Google found this thread and resolved it by moving the jumper to the primary position.
- When i powered everything back on the Remotely Controlled light went on during system bootup
- At that point the chlorinator is visible and controllable in your omnilogic system or via mobile app
Thank you