Hello Everyone, New Member here.
I am planning out my pool system upgrade and I have a question someone might be able to answer for me.
I purchased a Hayward MaxFlo VS 500 Omni to replace my old single speed Jandy. I currently run a SW system with Solar with no Hot Tub, just a fountain. The Omni kit with the pump comes with one Smart Relay, the base and the controller.
From what I can tell from the manuals, the OmniHub can control 2 valves (On my system that will be Solar and Fountain), it will control my pool light via the smart relay provided, the current Pentair SolarTouch controller will be removed and the temp sensors will be tied into the Omni.
Since I have a Hayward AquaRite system with a T-Cell 9 installed, I read the OmniHub can control the AquaRite with the additional communication board HLAQRPCB. So I went ahead and purchased this part so I had it for the installers when they arrive, but for the life of me I cannot find a manual on this part and how it gets installed. Does anyone have any insight into this? Does the flow switch on the AquaRite move into the OmniHub now, or does it stay in the AquaRite and the OmniHub reads it from there? I only ordered the PCB part, do I need anything else? Low Voltage cable? I know they sell an AquaRite system with the OmniHub and in that kit the PCB is included with everything you need, but if I am purchasing this separately, is the PCB all I need?
Thanks for your help!
I am planning out my pool system upgrade and I have a question someone might be able to answer for me.
I purchased a Hayward MaxFlo VS 500 Omni to replace my old single speed Jandy. I currently run a SW system with Solar with no Hot Tub, just a fountain. The Omni kit with the pump comes with one Smart Relay, the base and the controller.
From what I can tell from the manuals, the OmniHub can control 2 valves (On my system that will be Solar and Fountain), it will control my pool light via the smart relay provided, the current Pentair SolarTouch controller will be removed and the temp sensors will be tied into the Omni.
Since I have a Hayward AquaRite system with a T-Cell 9 installed, I read the OmniHub can control the AquaRite with the additional communication board HLAQRPCB. So I went ahead and purchased this part so I had it for the installers when they arrive, but for the life of me I cannot find a manual on this part and how it gets installed. Does anyone have any insight into this? Does the flow switch on the AquaRite move into the OmniHub now, or does it stay in the AquaRite and the OmniHub reads it from there? I only ordered the PCB part, do I need anything else? Low Voltage cable? I know they sell an AquaRite system with the OmniHub and in that kit the PCB is included with everything you need, but if I am purchasing this separately, is the PCB all I need?
Thanks for your help!