I have an EasyTouch8 and need a bit of guidance with the programming. My AUX relays control the following items:
F: IntelliFlow VS Pump
AUX1: Spa Blower
AUX2: Pool Light
AUX3: Spa Light
AUX4: Shelf Light
AUX5: Patio Lights (Group #1)
AUX6: Patio Lights (Group #2)
AUX7: <empty>
Questions:
1. I installed an actuator that, when opened, turns my bubblers on (water feature on our shelf). Where/how do I set this up and program to control so that from the ScreenLogic software and can on-demand open and close this valve when in pool mode? (I currently have three actuators installed on my equipment - one pool - one spa - one bubblers).
2. How should I best utilize the "Feature Circuit's" within the programming - I guess I don't fully understand these? Do I assign pump speeds to these?
3. Any other tips for programming via the "Configure ScreenLogic" interface would be appreciated...
F: IntelliFlow VS Pump
AUX1: Spa Blower
AUX2: Pool Light
AUX3: Spa Light
AUX4: Shelf Light
AUX5: Patio Lights (Group #1)
AUX6: Patio Lights (Group #2)
AUX7: <empty>
Questions:
1. I installed an actuator that, when opened, turns my bubblers on (water feature on our shelf). Where/how do I set this up and program to control so that from the ScreenLogic software and can on-demand open and close this valve when in pool mode? (I currently have three actuators installed on my equipment - one pool - one spa - one bubblers).
2. How should I best utilize the "Feature Circuit's" within the programming - I guess I don't fully understand these? Do I assign pump speeds to these?
3. Any other tips for programming via the "Configure ScreenLogic" interface would be appreciated...