Anyone happen to have a spare connector for an intellivalve???? I managed to damage one of mine - and need one with a "pigtail" about a foot or longer. I can solder the wires.....
Thanks!!!!
Thanks!!!!
Need a connector for an intellivalve..........
- Thread starter John_and_Val
- Start date
- Jul 21, 2013
- 52,475
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
JST XH 2.54MM 3 Pin connector. You can find them on Amazon.
www.troublefreepool.com
Actuator Connector type
I want to start the wiring for the pool controller actuators. I am trying to find the specs for the 3 pin connector. A search over here resulted in some people thinking they were a J.S.T. HX type. I found the Jandy 2711 connector but could not get the specs. I was hoping to buy some with the pig...
www.troublefreepool.com
Last edited:
Katodude
Silver Supporter
- Aug 22, 2017
- 2,596
- Pool Size
- 15000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Hayward Aqua Rite (T-15)
I have a few spares. I am up in West Palm. I should be home all day.
Also the pigtail is probably only about 6 inches.
Also the pigtail is probably only about 6 inches.
Ok. I am working alot during new years - but i will PM you when I am ready
Thank you!!!!
Thank you!!!!
