Since you guys got me sorted on my last question (thank you!), I'm back here with another one. I have a pool and spa. The pool company put two lights in the pool and programmed them with Hayward omnilogic. Since this is an ongoing project, I asked them after the fact to add a light to the spa as it was really dark at night. They ran the wire to where the pool lights are connected and controlled but they didn't connect or program the new light. I connected the wire and the light works but the color doesn't sync with the pool lights. Pool might be green while spa is red for example. Also for what it's worth there is one control wire from HVR1 to control the pool lights but not a second wire at least not yet to allow separate on/off and color selection. They clearly didn't finish the job yet so they'll be back out but for now I'm just interested in getting colors to align from the 1 connection so my question is what do I need to do to get the spa light programmed to match the pool?
Lighting automation
- Thread starter lambed3
- Start date
- Jun 7, 2017
- 9,966
- Pool Size
- 29000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Jandy Aquapure 1400
- Jul 21, 2013
- 65,062
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
The lights are probably configured for Omni Direct mode. The service techs didn’t go through doing it again to sync the lights. You will have to do it yourself. Go to configure, type in your MSP ID, edit, bodies of water , pool ,backyard lights. It should keep the same settings high lighted. When it gets to “ do you want to enable Omni Direct mode ?” Say yes . It will sync your lights.
