Good afternoon, earlier this summer I thought I had a leak I my return line but discovered that the leak was in my return valve as I had a slow but continuous run of water going through the backwash valve (runs underground direct to sewage line.... can see the valve below that allows me to check). I replaced the entire backwash valve and lubed it up and thought I had fixed it only to continue to lose water. Well I checked the backwash line again and the water is coming out fairly steady.
Does anyone have any experience with this? Do I need an entire new case that the valve goes in?
Thanks in advance
Does anyone have any experience with this? Do I need an entire new case that the valve goes in?
Thanks in advance