Hi all - Thank you for providing this forum! I have a question that I can't find any information about online - my chlorination readout on the panel of my Jandy TruClear SWG keeps defaulting to 100% each time the system comes on. I can set it lower (to 50%), but when I press "set", it still defaults back to 100% the next day. Any direction you might give towards a solution would be greatly appreciated.
Jandy TruClear Panel Issues
- Thread starter RobJWoodrum
- Start date
- Jul 21, 2013
- 53,182
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
Welcome to TFP.
I recollect a few people asking about this problem and I think it is a problem with the cell.
Have you contacted Jandy and made a warranty claim?
I recollect a few people asking about this problem and I think it is a problem with the cell.
Have you contacted Jandy and made a warranty claim?