I have a Jandy LXI Heater. Approx. 8 years on this heater. Tried to warm the pool to 87. It fires up, blows hot air, but pool goes up to 83 and stops.
Set on screen is 100. Water Temp on screen is 83.
I have an Aqualink automation system on it.
Reading about High limit and a temperate sensor on this unit. Could that be the problem? Not getting any errors.
Set on screen is 100. Water Temp on screen is 83.
I have an Aqualink automation system on it.
Reading about High limit and a temperate sensor on this unit. Could that be the problem? Not getting any errors.