Jandy Aquapure SWG Question

[joshuazzx]

Hi,
I am troubleshooting my Aquapure SWG system and had the following question.

My Aquapure system has firmware 08020A07, so on the salinity/flow sensor module I need to select PgmB as shown below.



On the Power Interface Board, there are two LEDs labeled as "A" and "B"(in below picture), one of the LED will lit during operation and it will alternates between A and B.



My question are

• Are the LED "A" and LED "B" associated with the PgmA and PgmB selection on the salinity/flow sensor?
• My salt cell seems only producing chlorine when LED "B" is lit. what could be the reason? the salt cell and DC cable are relatively new.

Thank you

 

[PoolGate]

No clue but here is the full troubleshooting manual for the AquaPure.

JANDY AQUAPURE WORKBOOK Pdf Download

View and Download Jandy AquaPure workbook online. AquaPure lighting equipment pdf manual download. Also for: Purelink, Nature2 fusion soft.

www.manualslib.com

 

[joshuazzx]

No clue but here is the full troubleshooting manual for the AquaPure.

JANDY AQUAPURE WORKBOOK Pdf Download

View and Download Jandy AquaPure workbook online. AquaPure lighting equipment pdf manual download. Also for: Purelink, Nature2 fusion soft.

www.manualslib.com

Thanks for the reply.

I have went through the diagnostic. It passed the tests when the LED "B" is lit. However when the LED A is lit, there is no voltage output to the cell. I do not know what controls which LED to lit.

You have the same system right? Is it possible to check which Program you selected and which LED is lit?

Thanks a lot