Jandy Aquapure No Flow

[Brutus10309]

Have a Jandy aqua pure saltwater cell & i have a “ no flow “ reading

is there a reset button that I have to hit inside the control box

enclosed is a picture of the control box

I cleaned the filter, added salt, backwashes, temp of water at 71 degrees

installed new cell last year as well

 

[ajw22]

Calibrating the tri-sensor is on page 3 in http://cdn.lesliespool.com/wpdf/r0537600_installation.pdf

If calibrating does no work then you may need to replace it.

Jandy Zodiac Flow Sensor Bad?

I'm trouble shooting service numbers on my Aquapure and wanted to run the entire scenario by some folks before I spend money on replacement parts. First error codes were the 125 & 194 - Clean Cell. I pulled cell and inspected it. No obvious build-up, but I cleaned it and got a few bubbles. Put...

www.troublefreepool.com

 

[RedLion]

When my Jandy salt cell shows no flow, I reset the breaker and that usually takes care of it.

 

[Hagefamily]

Have a Jandy aqua pure saltwater cell & i have a “ no flow “ reading

is there a reset button that I have to hit inside the control box

enclosed is a picture of the control box

I cleaned the filter, added salt, backwashes, temp of water at 71 degrees

installed new cell last year as well

Did you get this solved? I am having the same problem this year. The Salinity is measuring 3.1, pool temp 78, but No Flow. Using the Jandy PLC1400 and AquaPure control panel.

Hoping maybe I don't have to replace my SWG cell.

 

[RedLion]

Try resetting your breaker.

 

[Hagefamily]

I'll give it a try. If that doesn't work, I'll create a new post.

 

[Hagefamily]

Try resetting your breaker.

Thank you. Tried it twice but didn't make any difference.