My SWG is not working. Everything was purchased brand new last year and worked fine. Now it is not ready any water flow. I opened the unit and it is perfectly clean inside with no cal deposits. Any ideas what i can look for? The codes are 172, 185, 186
Jandy Aquapure Code 172 no flow
- Thread starter rd383
- Start date
- May 3, 2014
- 58,451
- Pool Size
- 6000
- Surface
- Fiberglass
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-40
If it is brand new, you can file a warranty claim and let the builder or Jandy figure it out.
My readings were 3.1 gpl, 74 degrees and 91degrees. What does this mean, the board is bad?
I bought them online last year and installed myself. I don't have any Jandy dealers near me and just replaced what was already installed when we bought the house.
Can you show the trisensor both sides, inline module and the plug end?
Is the module set to the correct setting?
If the power interface board firmware is 02110A10 or 01220A15, you use program A, otherwise you use program B.
www.troublefreepool.com
Is the module set to the correct setting?
If the power interface board firmware is 02110A10 or 01220A15, you use program A, otherwise you use program B.
Jandy AquaPure SWG - Further Reading
www.troublefreepool.com
Seems to indicate a bad trisensor.
Is everything new?
Just file a warrant
Can you show the trisensor both sides, inline module and the plug end?
Is the module set to the correct setting?
If the power interface board firmware is 02110A10 or 01220A15, you use program A, otherwise you use program B.
Jandy AquaPure SWG - Further Reading
View attachment 487161
Attachments
There is plenty of water coming out of the jets so I assume the pressure is good. I'll reach out to the supplier i purchased the unit from and see what they say. Thanks for your help
- Jun 7, 2017
- 9,087
- Pool Size
- 29000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Jandy Aquapure 1400
It can't hurt to check the power cord, but a bad cord would produce a 120, 121, 123 or 125 code.
The 185 and 186 codes indicate a trisensor problem.
I replaced the tri sensor and everything is working now. Thank you all for your help!!