I’m getting 124, 170, and 193. It’s a compupool 1400 cell that was bought last season. The board test seems like it’s good. Is this most likely a sensor issue? It’s a newer sensor maybe 3 years old.
Jandy aquapure 1400 errors
- Thread starter Billfromtr
- Start date
- Jul 21, 2013
- 66,259
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
Welcome to TFP.
Probably a bad cell causing high current.
Probably a bad cell causing high current.
- 120 Higher than normal current to cell
- 170 Possible front board service condition or unit not correctly wired to 120 VAC
- 193 Measured significant cell current when SCRs were turned off. (Generates 170 code – front board service)
Similar threads
