I recently installed a new CompuPool SWG system to replace my old Shasta Chlorinator. The new control panel has red LED warning lights for high salt, low salt, and no water conditions. According to the manual, if any of these conditions are detected, the current is removed from the cell to prevent damage.
My panel occasionally will show one of those 3 conditions. Saturday and Sunday, the system worked fine. Monday, I had a "high salt" warning. Tuesday I had a "water fault" warning, and Wednesday it worked without any warnings. This morning the "low salt" warning LED was on! WTF?!
Has anyone had any experience good or bad with the CompuPool control panels? I'm thinking the panel or sensor is hooped, and I want to get it fixed while under warranty.
Any advice or input is appreciated!
Thanks, Garry
My panel occasionally will show one of those 3 conditions. Saturday and Sunday, the system worked fine. Monday, I had a "high salt" warning. Tuesday I had a "water fault" warning, and Wednesday it worked without any warnings. This morning the "low salt" warning LED was on! WTF?!
Has anyone had any experience good or bad with the CompuPool control panels? I'm thinking the panel or sensor is hooped, and I want to get it fixed while under warranty.
Any advice or input is appreciated!
Thanks, Garry