Issue with Ichlor 30

[Johnny Hurricane]

Have problem after a little over six months the Ichlor has an issue.
After start up the salt light flashes red and green then settles as a flashing red only, the cell light remains blank and the flow light is green.
The diagnostic check is as follows.
Total cell hours 1180
Temperature 84 F
Salinity LO
Cell voltage ----
Firmware r 500
I assume that there is no CL being produced.
Before the Salinity went to LO it read less than 1800 but the actual salinity was close to 4000.
Any suggestions what to do?
Thanks

 

[mknauss]

Submit a warranty claim. Sounds like the thermistor in the flow switch failed.

 

[czego82]

Did you ever resolve the issue? I have the same problem