I checked my Cl level today and it was 0. I went and looked at my IC40 SWG and all the lights were off. I opened up the power center and the green light was on. I did a continuity check on the fuse and it tested ok for continuity. I pulled the power cord from the IC40 out of the power center and tested between the four connections. When testing between the two that run parallel to the front face of the power center, I get between 28-30 VDC. Between any other combination gives me nothing. My understanding is this proves the power center is fine because only one pair is supposed to show voltage, correct?
Does this mean I need a new SWG? Is there anything else I should test before dropping $700 on a new SWG? This is the second IC40 I will have purchased since buying the house 12 years ago, that about the norm? Any other SWGs I should look into or should I just stick with the IC40?
THANKS....
Does this mean I need a new SWG? Is there anything else I should test before dropping $700 on a new SWG? This is the second IC40 I will have purchased since buying the house 12 years ago, that about the norm? Any other SWGs I should look into or should I just stick with the IC40?
THANKS....