Beginning our 4th summer. Struggled last and so far this year with cloudy water in our 20x44 vinyl liner salt water pool. I think I’m learning that by having my PB just “open” and I’ll do the rest means I knew nothing about annual stabilizer and the problems my fill water would cause if I didn’t adjust TA immediately. Here to continue learning. We run our pump almost 24/7. Our heater is a heat pump so I believe that’s why it runs at all times just at much lower speeds at some times. We also have an auto cover so it’s covered from sun when not in use. With that information, any suggestions on what % our salt generator should be set at?
Introduction
- Thread starter Hilldale
- Start date
- May 3, 2014
- 62,687
- Pool Size
- 6000
- Surface
- Fiberglass
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-40
Welcome to the forum!
Post up your questions in the appropriate sub forum.
I suggest you read through Pool Care Basics - Trouble Free Pool and even look at a few of our videos TFP-TV - Trouble Free Pool
Post up your questions in the appropriate sub forum.
I suggest you read through Pool Care Basics - Trouble Free Pool and even look at a few of our videos TFP-TV - Trouble Free Pool
- Jun 22, 2014
- 52,018
- Pool Size
- 17888
- Surface
- Fiberglass
- Chlorine
- Salt Water Generator
- SWG Type
- CircuPool RJ-45 Plus
