Hello all! We’re still in the process of this never ending set up of our Intex Ultra XTR 32 x 16. Our liner/foam padding ground work was all level until this past week of torrential rain and one of the short sides went down about an inch. Fortunately our pavers are unaffected and level all around within 1/16”. Is this a huge issue? The rain water slopes to one side of the liner but thats with only a couple inches of water in the pool. We were hoping to begin filling today. Your help as always is greatly appreciated!
Intex ultra xtr pavers are all level but liner has dipped one inch on one side..,
- Thread starter Lucylocket74
- Start date
- Jul 21, 2013
- 52,486
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
Something is not level if the water is sloping. You need to figure out what is off.
How did you determine things were level?
Post pics and maybe we can help spot somethings.
www.troublefreepool.com
How did you determine things were level?
Post pics and maybe we can help spot somethings.
How to level above ground pool - Further Reading
www.troublefreepool.com
We used a water level for all the pavers. The foam pad and a little sand under neath it is what is sloping approximately 3 or 4 ft in from the short side. I don’t think the picture will show much, but that’s the ground height difference on each short side comparatively. This forum won’t always let me upload the higher quality photos from my iPhone.
Attachments
Hi ! We are in the process of putting up the same pool. I'll follow along and maybe we can learn together. Good luck. I fully understand how much work you've got into just to get to this point.
-Allen
-Allen
