Hello,
I've been searching in this forum for an answer to a very specific doubt I have but couldn't find any,
so I try to ask:
I'm planning to install the obovementioned AGP on to a slope;
some building is needed as I want to create a U shaped wall inside wich the pool will be placed.
I've studied pool dimension and some advice given by forum user in order to grant enough room on the side of the pool to complete installation procedures, still there is something that is not quite clear to me:
installation manual says:
[...]
"Starting with one side, slide the “A” beams first into the sleeve openings located in each corner. Continue with “B” beam snapping into the “A”
beam, and another “C” beam snapping into the “B” beam.
[...]
Start the "D-E-F" combination for pool's short sides
by inserting the "D" beam first into the opening.[...]
My question is, given that the order of the beams is mandatory, is mandatory that I have to slide in (referring to long side) first A then Bs finally C or could I procede backwards and insert (starting on the opposite opening) first C then Bs finally A?
IDEM regarding short size, could i slide in F first then Es finally D?
Hope someone can help.
TIA
Giuseppe (Italy)
Signature is empty since I have non pool!
I've been searching in this forum for an answer to a very specific doubt I have but couldn't find any,
so I try to ask:
I'm planning to install the obovementioned AGP on to a slope;
some building is needed as I want to create a U shaped wall inside wich the pool will be placed.
I've studied pool dimension and some advice given by forum user in order to grant enough room on the side of the pool to complete installation procedures, still there is something that is not quite clear to me:
installation manual says:
[...]
"Starting with one side, slide the “A” beams first into the sleeve openings located in each corner. Continue with “B” beam snapping into the “A”
beam, and another “C” beam snapping into the “B” beam.
[...]
Start the "D-E-F" combination for pool's short sides
by inserting the "D" beam first into the opening.[...]
My question is, given that the order of the beams is mandatory, is mandatory that I have to slide in (referring to long side) first A then Bs finally C or could I procede backwards and insert (starting on the opposite opening) first C then Bs finally A?
IDEM regarding short size, could i slide in F first then Es finally D?
Hope someone can help.
TIA
Giuseppe (Italy)
Signature is empty since I have non pool!
