intermatic e10694 pool timer Help

[Lykly]

I have a clock timer that stopped working. I need to replace it but not sure what model. It has intermatic E10694 stamped on it. It is 220 going into this and I believe 110 output to SWG controller. I am not an electrician, but I feel like I do this job myself by wiring at exactly the same way - if I’m sure I got the right replacement unit. On the far right of the picture, it appears to be a white wire that has been taped in black tape, I don’t think because of damage.

 

[Rancho Cost-a-Lotta]

If you shut off the power and push up on the tab on the upper left, the timer will pull forward. The model number should be printed on the back. It does appear to be a 240 volt model, T104. If there is 220 going into it, there should be 220 going out to the swg controller.

 

[Jimrahbe]

Lykly,

You need a T104M

Amazon.com

Your system gets 240 volts in and sends 240 volts out. The white wire has black tape to show it is a hot lead and not a White Neutral wire.

Thanks,

Jim R.

 

[Lykly]

Thank you!!

 

[Lykly]

Lykly,

You need a T104M

Amazon.com

Your system gets 240 volts in and sends 240 volts out. The white wire has black tape to show it is a hot lead and not a White Neutral wire.

Thanks,

Jim R.

Ordered - thanks for the help and the link.

 

[Lykly]

Lykly,

You need a T104M

Amazon.com

Your system gets 240 volts in and sends 240 volts out. The white wire has black tape to show it is a hot lead and not a White Neutral wire.

Thanks,

Jim R.

Up and running- thanks again!